• Soft (60A Duro), flexible abrasion resistant rubber to absorb high localised shear forces and protect the belt.
• Advanced bonding system provides 100% rubber tear adhesion to handle localised shear forces, extremes of temperature and wet operating conditions. This bonding system eliminates the chance of the lagging debonding from the pulley shell and the chance of separation of the lagging at the joins between strips.
• High performance abrasion resistant synthetic elastomer with typical abrasion of 29 mm3 volume loss (DIN53516 Method A Non rotating).
• Diamond pattern with large diamonds and deep grooves to provide flexibility to handle localised shear stresses and protect the conveyor belt.
• Reusable filled silicone infill strip used during lagging application curing process to ensure even pressure on surface.

Elastotec Extreme Rubber Lagging is designed for the following conditions:

• Uneven belt top cover profile due to wear.
• Presence of carry back that can cause build up and resultant belt damage
• High power, high tension conveyor belts (Up to 3,000 kN belt tensions).
• Extreme temperatures from -40°C to +60°C.
• Extended outdoor operational service.
• To protect the belt from high localised shear forces that result from belt top cover wear.

Elastotec Extreme Rubber Lagging is designed for use in the following demanding applications:

• Non drive pulleys with requirement to extend service life.
• Large non drive pulleys on high power belt conveyors that are in contact with the dirty side of the belt.
• This includes gearless drive conveyors with power ratings of up to 6MW.
• Pulleys where high levels of carry back are present.
• Pulleys in locations that are difficult to access and where pulley change out is difficult.
• Critical locations where unplanned conveyor downtime due to lagging failure must be eliminated.
• Conveyors that operate across a wide temperature range.
• Pulleys subjected to high localised shear forces due to uneven belt profile caused by wear of the belt top cover.